LEGRAND celiane - Page 98

SCS BUS AUTOMATION SYSTEM
CONFIGURATION
III-140
Controls: addresses and types of controls
Also the control devices have A and PL positions, for the
definition of the address of the devices receiving the controls
(actuators).
These positions require numeric configurators with graphics,
which enable the device to send the corresponding control, in the
various modes listed in the table below.
Addressing mode of devices
Basic concepts for the configuration
of actuators and controls
Type of control Control device Actuator device
Configurator housing Configurator value Configurator housing Configurator value
Point-point
A
PL
1 – 9
1 – 9
A
PL
1 – 9
1 – 9
Room
A
PL
AMB
1 – 9
A
PL
1 – 9
1 – 9
Group
A
PL
GR
1 – 9
G1
G2
G3
1 – 9
1 – 9
1 – 9
General
A
PL
GEN
–
AUXILIARY
control
A
PL
AUX
1 – 9