LEGRAND MyHOME - Automatic Function in Comfort, Eco, and Protection Mode

1514
Thermostat with display
Installer manual
5.2.2 Automatic function in Comfort, Eco, and Protection mode
Automatic changeover depends on the operating mode selected: comfort, eco, or protection.
In this case, the heating and cooling ranges must have been previously set in the corresponding
modes (see paragraph 6.3).
Therefore, two parameters for each mode must be set: a high set-point to set in the cooling func-
tion, and a low set-point to set in heating mode.
5 Functions and operating modes
Example of temperature range settings
The above example indicates the temperature set-point pairs for Eco mode and Comfort mode.
The cooling system will activate when the temperature exceeds the upper set-point, while the
heating system will activate when the temperature falls below the lower set-point.
COOLING
RANGE
HEATING
RANGE
32°
22°
24°
14°
SET-POINT ECO
SET-POINT ECO 18°
28°
COOLING
HEATING
32°
22°
24°
14°
SET-POINT COMFORT
SET-POINT COMFORT
21°
25°
COOLING
HEATING
COOLING
RANGE
HEATING
RANGE
ECO Mode COMFORT mode
COOLING
RANGE
HEATING
RANGE
32°
22°
24°
14°
SET-POINT ECO
SET-POINT ECO 18°
28°
COOLING
HEATING
32°
22°
24°
14°
SET-POINT COMFORT
SET-POINT COMFORT
21°
25°
COOLING
HEATING
COOLING
RANGE
HEATING
RANGE