LEGRAND Tynetec Advent XT2 - RADIO DEVICE PROGRAMMING; Adding and Removing Radio Devices; Updating XT2 System with Devices

Doc No. FM0817 issue 1 Page 19
19. RADIO DEVICE PROGRAMMING
Press the Settings button on the Home page and the Enter Password box will appear.
Press the Manager (or Engineer) button, enter the 4-digit password and press the Programming button.
Select the Program Radio Devices option from the tabs along the bottom of the screen;
Press Flat ID and use the on-screen keypad to enter the flat number you’re adding (or removing) a radio device
to/from.
Press Radio ID and enter the 10-digit alpha numeric radio ID – this will be printed on the label attached to the 869MHz
radio device that is to be added/removed from the system.
Press Room Locations and select where the radio device is situated from the on-screen options shown below;
Press the Send button to update the XT2 system.
To remove a radio device from the XT2 system enter the same details then press Remove (instead of Send).
Press Close when done.