LEGRAND Tynetec Advent XT2 - CALL ROUTING PROGRAMMING; Configuring Call Routing Directions; Managing Call Route Numbers

Doc No. FM0817 issue 1 Page 25
23. CALL ROUTING PROGRAMMING
Call Routing is used to set a direction (onsite/offsite) and the specific extension or offsite telephone number that a call
will be routed to on an individual flat basis during a set time period each day. Up to 8 routes can be set per flat.
From Settings on the Home page, enter the Manager (or Engineer) password, then press the Programming button.
Select the Call Routing option from the tabs along the bottom of the screen.
Press Flat ID and use the on-screen keypad to enter the flat number required.
Press the Request button to view the current Call Routing settings for the flat number selected.
Press Route Number and select from 01 to 08;