An optional 869MHz radio door contact can be used to monitor if a resident leaves their flat during a pre-set time
period each day. The start and end time can be set on an individual flat basis. If a resident leaves their flat during the
set period a wandering alarm will be reported.
From Settings on the Home page, enter the Manager (or Engineer) password, then press the Programming button.
Select the Client Wander option from the tabs along the bottom of the screen.
Press Flat ID and use the on-screen keypad to enter the flat number required.
Press the Request button to view the current Client Wandering settings for the flat number selected.
Press Start/End Time and use the keypad to enter the start and end times for the monitoring period;
Press Rtn on the keypad and buttons for the days of the week will be displayed;
Select which days Monday to Sunday that the wandering feature will be active – blue is enabled, grey disabled.
Set Wander Enabled to enable the feature – blue is enabled, grey disabled.
Press the Send button to update the XT2 system.
Repeat for another flat number.
Press Table to view a list of Client Wandering settings for all flats.
Press Close when done.
To Next Page
Loading...
Need help?
General
