Leica Envisu C Series User Manual

Hardware User Manual
Envisu C-Series SDOIS / 9054-10011 / Revision N 16
UPM LED Display
UPS Status
UPM output on
Battery charge status in 20% increments
UPM load status in 20% increments
UPM in battery operation due to improper incoming AC
UPM overloaded
Battery fault or battery disconnected
High incoming AC: UPS has to reduce the output
compared to the incoming power level
Low incoming AC: UPS has to increase the output
compared to the incoming power level
Fault/error
UPM temperature too high
UPS Status Indicators
Warning! This unit is intended to be used in a system that has a
grounded neutral conductor. Operating this equipment without proper
grounding may present a risk of electrical shock. Do not use AC
adaptors with only two conductors to connect the input line cord to the wall
socket as this will not connect the earth ground to the equipment.
Warning! This equipment services power from more than one source.
The output receptacles may have voltage present even when the unit
is unplugged. Unplugging the UPS does not remove the electrical charge.
To ensure that the UPS is off, turn the power switch “OFF” before
unplugging the UPS from the wall outlet.
.

Leica Envisu C Series Specifications

General

Brand	Leica
Model	Envisu C Series
Category	Laboratory Equipment
Language	English