Leica Envisu C Series User Manual

Hardware User Manual
Envisu C-Series SDOIS / 9054-10011 / Revision N 19
System Power Up and Power Down
Powering Up the System
To power up the Leica Spectral Domain Ophthalmic Imaging System, use the following steps:
1. Power on the system switch located on the front of the UPS.
2. Check to insure the SDOIS Scan engine and Hand Held Probe interface box are
powered on.
3. Power on the computer.
4. Once the computer has finished the boot cycle, launch the IVVC image acquisition
software application using the applicable desktop shortcut.
Powering Down the System
About Powering Down the System
The light source in the SDOIS engine has a limited lifetime and therefore, the system should
be powered down at the end of each day.
Points to consider before powering down the system:
• Exporting patient exams
• Archiving patient exams
• Backing up system data
Power Down
To power down the Leica Spectral Domain Ophthalmic Imaging System, use the following
steps:
1. Close the IVVC Image Acquisition Software Application.
2. Shut down the system computer using the standard operating system shut down
procedure.
3. Once the system computer shut down sequence is complete, power off the system
switch located on the front of the UPS. To turn the UPS system off press and hold the
power switch for at least 2 seconds.
Note:
The SDOIS engine and probe interface box must be powered on
prior to starting the IVVC image acquisition software application.
Note:
Consult the IVVC Software Users Manual for proper instructions
on exporting and archiving patient data along with backing up
system data.

Leica Envisu C Series Specifications

General

Brand	Leica
Model	Envisu C Series
Category	Laboratory Equipment
Language	English