Leica IP C - Page 43

43
Leica IP C
Instrument Setup 4
Warning
Do not reinstall a used transport plate (→ "Fig. 36-2"), as it will no longer completely seal the print
head.
To prevent damage to the print head, always use the red replacement plate (→ "Fig. 36-1") when
printing.
1
2
Fig. 36
6. Push the small lever (→ "Fig. 35-1") back down into its original position.
7. Press any key of the control panel (→ "Fig. 37-1") to reposition the print head and make the
printer ready to operate.
Caution
If no key is pressed, the print head will close automatically 150 seconds after opening to prevent it
from drying out. An acoustic signal (5 beeps) will sound after 120 seconds, after which the final 30
seconds will be counted down on the display (→ "Fig. 37-2").
1
2
Fig. 37
8. Press the red retaining bracket (→ "Fig. 38-1") down and and hold it in this position, so that the
transport cartridge can be removed.
9. Pull the transport cartridge (→ "Fig. 38-4") approx. 30 mm out of the instrument until the INK
EMPTY LED lights up (→ "Fig. 38-2").
10. Retighten the red cap (→ "Fig. 38-3") and then remove the cartridge completely (→ "Fig. 38-5").
11. Release the red retaining bracket.