Operation TPS1200+ 53
3.2 Autodetect Behaviour
Description • The instrument incorporates an autodetect behaviour and automatically detects
the following devices:
• SmartAntenna
• RadioHandle
• radios/modems in clip-on-housings
• Whenever a device is attached, the instrument responds with two short beeps.
• Whenever a device is removed, the instrument responds with one long beep.
SmartAntenna
Adapter
• SmartAntenna Adapter cannot be detected by the instrument but the devices
that are attached to SmartAntenna Adapter are automatically detected. These
devices are SmartAntenna and radios/modems in clip-on-housings.
Radio/Modem
in clip-on housing
• All radios and modems that are built into a clip-on housing are automatically
detected by the instrument when attached to SmartAntenna Adapter, but the
device settings are not automatically set.
SmartAntenna • SmartAntenna is automatically detected by the instrument when it is attached
and STATUS Interfaces is automatically updated.
• Certain functionality can only be executed if SmartAntenna is attached.
To Next Page
