LEITZ ICON - Printer Care and Troubleshooting; Cleaning Procedures; Printer Errors and Jams

Leitz Icon Printer User Guide Caring for the Printer
21
Caring for the Printer
The Leitz Icon printer requires very little maintenance. You may occasionally need to clean the label cartridge
compartment, the exterior of the printer, and the paper path.
If you experience lighter than normal printing or labels are protruding from the label cartridge when the cartridge is
removed from the printer, use the included cleaning card to clean the paper path.
To clean the label cartridge compartment
1.Push the button on the top of the printer to open the cartridge door.
2.Wipe the label cartridge compartment with a clean, dry, lint-free cloth.
To clean the exterior of the printer
 Wipe the exterior of the printer with a soft, damp cloth.
To use the cleaning card
1.Push the button on the top of the printer to open the cartridge door.
2.Remove the label cartridge as described in Unloading Labels on page 14.
3.With the label guide latch in the open position, insert the cleaning card into the label feed slot approximately 1.2” (3
cm).
4.Close the label guide latch.
5.Press and hold until the cleaning card exits through the label exit slot.
6.Flip the cleaning card over and repeat steps 3-5.
Troubleshooting
This section includes information about what to do if you encounter a problem with your printer. If you need further
assistance, please visit the Support section of the Leitz website at www.leitz.com/icon/support.
Printer Errors
In addition to indicating the power and wireless connection status of the printer, the power and wireless status lights can
also indicate printer errors and other information.
For information about the power and wireless connection status, see Status Lights on page 6.
NOTE
Do not use cleaning tissues or chemical substances which might damage the surface
NOTE
Keep the cartridge door open while using the cleaning card.
Error/Status Power Status Light Wireless Status Light
Printer out of paper
or
Label loading failed
Flashing once per second As is; indicates wireless status
Cutter jam Both status lights flash simultaneously twice per second
Invalid or unreadable label cartridge Status lights flash alternately; each light flashes once per second
WPS connection in progress On (Solid) Flashing once per second