28
− Keep the lever (6) in the “boundary
wetting” position until the chemical
inductor is half-filled.
ATTENTION! Never operate the lever
(11) of the canister rinsing if there is no
canister pushed over the canister rinsing
nozzle. The canister must only be rinsed
with clean water.
− Put the lever (9) in the “agitator ON”
position.
− Put the lever (6) in the “boundary
wetting OFF” position.
− Put the metered induction valve (8) in
the “induction ON” position so that the
chemical inductor remains 50 % full.
− Fill pesticide into the chemical inductor.
− Rinse empty canister if necessary after
induction of the pesticide is complete.
− For this, swivel up the canister rinsing
nozzle, push the canister over it, put
the lever (11) for the canister rinsing in
the “ON” position and rinse the
canister.
− Put the lever (11) for the canister
rinsing in the “OFF” position.
− Put the lever (6) in the “boundary
wetting ON” position in order to clean
the chemical inductor.
− Put the induction valve (8) completely
into the “induction ON” position.
− Remove the canister from the canister
rinsing nozzle.
5
3
7
10
6
11
9
To Next Page
Loading...