Page 93
Table 59. Menu Interface (Level 1 - SERVICE)
Note: Available menu options are dependent on hardware configuration.
Level 1
WHEN SELECTED (PRESS BACK TO RETURN TO
THE PREVIOUS MENU)
Use the Adjust and set values
arrows to scroll up or down for
selection options.
Level 3Level 2
SOFTWARE
UPDATE
SOFTWARE
UPDATE
SOFTWARE UPDATE (EITHER
THE UPDATE WILL BE SUC
CESSFUL OR THE FOLLOW
ING MESSAGES WILL AP
PEAR. SW UPDATE FAILED
OR SW UPDATE FILE NOT
FOUND.
NOTE: IF USB FLASH DRIVE IS NOT INSTALLED OR
THE M3 UNIT CONTROLLER CANNOT READ THE
FLASH MEDIA, A MESSAGE WILL APPEAR “NOT AP
PLICABLE EQUIPMENT NOT PRESENT.”
OFFLINE
CLEAR DELAYS CLEAR DELAYS = YES OR NO.
RESET
CONTROLLER
RESET CONTROLLER = YES
OR NO.
NOTE: THIS REBOOTS THE M3 CONTROLLER. NO
CONFIGURATION SETTINGS ARE CHANGED.
CONTROLLER
LOCKOUT
CONTROLLER LOCKOUT = YES OR NO.
NOTE: PARAMETERS AVAILABLE ARE DEPENDENT ON MODEL NUMBER AND CONFIGURATION ID 1 AND 2 SETTINGS.
To Next Page
Loading...
Need help?
General
