Page 94
Table 60. Menu Interface (Level 1 - SETTINGS)
Note: Available menu options are dependent on hardware configuration.
Level 2 Level 3 Level 4 Level 5
USE THE ADJUST AND SET VALUES AR
ROWS TO SCROLL UP OR DOWN FOR SE
LECTION OPTIONS.
RTU OPTION
BLOWER
SPEEDS
BLOWER HEAT = XXXX CFM
BLOWER COOLING HIGH = XXXX CFM
BLOWER COOLING LOW = XXXX CFM
BLOWER VENTILATION = XXXX CFM
ON (TARGET XXXX CFM) ADJUST BLOWER RPM - XXXX RPM
A BOX (NON-EP) -
HEATING, HIGH
SPEED AND LOW
SPEED
HIGH SPEED = %
LOW SPEED = %
ADJUST BLOWER % = XX%
ADVANCE AIRFLOW
A BOX AND B BOX
OR BIGGER
HEATING, COOLING
HIGH, COOLING
MED, COOLING
MED HIGH,
COOLING MED
LOW, COOLOW
LOW AND
VENTILATION
BLOWER CALIBRATION (HEATING, HIGH
SPEED,
LOW SPEED OR VENTILATION = CALIBRA
TION
DONE OR TURN BLOWER ON.
IF TURN BLOWER ON IS SELECTED, BLOWER
ON
XXXXX > TURN BLOWER OFF= NO OR YES.
VFD BYPASS VFD BYPASS DISENGAGED ENGAGE? = NO OR YES
DAMPER
ECONOMIZER ENTHALPY OFFSET = X MA
ECONOMIZER TEMP ECON TYPE = TEMPERATURE OFFSET OR TEMPERATURE SETPT
ECONOMIZER OAT SETPOINT = XX.X F
FREE COOLING SUPPLY AIR SETPOINT = XX F
OUTDOOR AIRFLOW = XXX CFM
ADVANCE AIRFLOW ALARMS = ENABLED OR DIS
ABLED (ONLY VISIBLE IF CONFIGURATION ID 1,
POSITION 2 IS SET CORRECTLY).
ADV AIRFLOW ALARMS LO SPLY AIRFLOW ALM
= XX%
ADV AIRFLOW ALARMS LO OD AIRFLOW ALM =
XX%
ADV AIRFLOW ALARMS HI OD AIFLOW ALM =
XX%
ADV AIRFLOW ALARMS ALM TRIGGER PERIOD
= XXXX SEC
MIN DAMPER POSITION BLOWER ON HIGH = X.X %
MIN DAMPER POSITION BLOWER ON LOW = X.X %
DEMAND CONTROL VENT DAMPER START OPEN = XXXX.X PPM
DEMAND CONTROL VENT DAMPER FULL OPEN = XXXX.X PPM
DEMAND CONTROL VENT > DAMPER MAX OA CFM = X CFM
(ONLY VISIBLE IF CONFIGURATION ID 1, POSITION 2 IS SET CORRECTLY).
DEMAND CONTROL VENT DAMPER MAX OPENING = XXX.X%
POWER EXHAUST ON BY ECON TRAVEL = XX.X %
FRESH AIR HEATING
ENABLE FAH = YES OR
NO
FRESH AIR HEATING FAH SETPOINT = XX F
FRESH AIR COOLING
ENABLE AFC = YES OR
NO
FRESH AIR COOLING AFC SETPOINT = XX F
DEHUMIDIFIER
SENSOR TYPE=LOCAL
SENSOR. NETWORK
SENSOR, REHEAT DI4 OR
NONE
= NONE OR REHEAT DI4
= LOCAL SENSOR
OR NETWORK
SENSOR
DEHUMIDIFIER DEHUMID
SETPOINT = XX.X %
DEHUMIDIFIER DEHUMID
DEADBAND = X.X %
EDIT PARAMETER ENTER DATA ID=XXX
To Next Page
Loading...
Need help?
General
