Lennox RG10F2-MMA User Manual

2
General
The RG10F2-MMA is a wireless
programmable controller for the MLB/
MPC outdoor units with MMA indoor
units. It is capable of executing timed
schedules for daily operation. These
instructions are intended as a general
guide and do not supersede local codes
in any way. Consult authorities having
jurisdiction before installation.
Requirements
Verify the power supply has been
turned o󰀨 before beginning installation.
This controller should be used only as
described in this manual.
Do not install the controller on exterior
walls (where there is unconditioned
space on opposite side of wall) or in
locations where direct sunlight may be
present.
Remote Controller Specications
Model RG10F2-MMA
Rated Voltage 3.0V
(Dry batteries, AAA)
Signal Receiving
Range
26 feet (8 meters)
Environment 23°F~140°F
(-5°C~60°C)
Handling the Remote Controller
Inserting and Replacing Batteries
1. Slide the back cover on the remote
controller downward, exposing the
battery compartment.
2. Insert the batteries; match the (+)
and (-) ends of the batteries with
the symbols inside the battery
compartment.
3. Slide the battery cover back into
place.
Figure 1. Removing Battery Cover
NOTE: For optimum product
performance: Do not mix old
and new batteries, or batteries
of dierent types. Do not
leave batteries in the remote
controller if it will not be used
for more than two months.

Lennox RG10F2-MMA Specifications

General

Brand	Lennox
Model	RG10F2-MMA
Category	Controller
Language	English