8
FAN Mode
1. Press the MODE button to select FAN
mode.
2. Press FAN button to select the fan
speed: AUTO, LOW, MED, HIGH.
3. Press the ON/OFF button to start the unit.
NOTE: The temperature can not be
set while in FAN mode. As a
result, your remote controller’s
LCD screen will not display
temperature.
Setting the TIMER
TIMER ON
1. Press TIMER ON to initiate the ON
time sequence.
1
2
3
2. Press the TEMP or TEMP
button to set the start time for the unit.
3. Point the remote controller toward the
unit and wait for one second.
The TIMER ON function is set.
TIMER OFF
1. Press TIMER OFF to initiate the OFF
time sequence.
2. Press the TEMP or TEMP
button to set the end time for the unit.
3. Point the remote controller toward the
unit and wait for one second.
The TIMER OFF function is set.
NOTE: When setting the TIMER
ON or TIMER OFF, the time
will increase by 30 minutes
increments with each press, up
to 10 hours. After 10 hours and
up to 24 hours, it will increase in
1 hour increments. (For example,
press 5 times to get 2.5h, and
press 10 times to get 5h. The
timer will revert to 0.0 after 24.)
Cancel either function by setting
its timer to 0.0h.
To Cancel TIMER ON/TIMER OFF
Cancel either function by setting the timer
to 0.0h.
To Next Page
Loading...
