Figure 87. Removing a DDIC
6. If the DDIC does not pop up, perform steps 1 and 2 simultaneously in above figure. The DDIC will pop up
slightly from the slot.
7. Lift the DDIC out of the slot, as shown in the following figure.
Figure 88. Removing a DDIC
Important: If you are not going to replace the drive immediately, close the drawer (see “Closing a Drawer”
on page 85) so that correct airflow and cooling are maintained in the enclosure.
Inserting a DDIC
Important: Failed drives must be replaced with approved drives. Contact your storage supplier for details.
1. If the relevant drawer is not already open, open it using the instructions in “Opening a Drawer ” on page
84.
Chapter 6. Module Removal and Replacement 87
To Next Page
Loading...
