Figure 82. Removing a 2.5” Drive Carrier Module (2)
Dummy Carrier Module Removal/Replacement
Dummy drive carrier modules are removed and replaced in the enclosure simply by pulling the module out of
the enclosure or pushing it into place.
Opening a Drawer
Note: 5U enclosures only.
1. Make sure the anti-tamper locks are not engaged. The red arrows on the locks point inwards if the locks
are disengaged (see Figure 83 “Anti-tamper Locks (shown disengaged)” on page 84). Unlock them if
necessary by rotating them counterclockwise using a screwdriver with a torx T20 bit.
Figure 83. Anti-tamper Locks (shown disengaged)
84 Lenovo Storage D1212/D1224/D3284Hardware Installation and Maintenance Guide
To Next Page
Loading...
