3. Cam the carrier home. The camming lever on the carrier will engage into a bay in the enclosure.
Continue to push firmly until the handle fully engages. A click should be heard as the latch engages and
holds the handle closed (see Figure 80 “Installing a 2.5” Drive Carrier Module (2)” on page 83).
Important: Make sure that the handle always opens from the top.
Figure 80. Installing a 2.5” Drive Carrier Module (2)
Note: Removal is the reverse of this procedure (press on the latch to release the handle). Please refer to
Figure 81 “Removing a 2.5” Drive Carrier Module (1)” on page 83 and Figure 82 “Removing a 2.5” Drive
Carrier Module (2)” on page 84.
Figure 81. Removing a 2.5” Drive Carrier Module (1)
Chapter 6. Module Removal and Replacement 83
To Next Page
Loading...
