Syntax:
help [[type] | [cmd]]
type
The command classification to list
cmd The specific command for which the usage shall be retrieved
Example:
0+03:42:33.775 M0 GEM> help
Supported commands:
change_password To change Current User Password
cleardriveindicator Clears the drive indicator LED
ddump System-wide diagnostic dump
ddumpo Ordered system-wide diagnostic dump
exit To logout from the cli connection
getboardid Get this board ID and mode
getvpd List all VPD information
help Displays command information
hid_set_ident
Set/clear enclosure identify mode
ipconfig Set IP Configuration in VPD
logcmt Insert comment in logdump
logdump Display logged msgs
logdumpnv Display Non-Vol logged msgs
poweroffdrive
Powers off a drive (includes spin-down)
powerondrive
Powers on a drive (includes spin up)
report_faults Reports all system-wide faults
reset_saved_zone_info Erases saved zone information from flash and resets the context with default values
set_encl_id Set enclosure ID
set_zone_mode Change default configuration for zoning
setcanisterindicator
Set/Clear the local canister indicator status
setdriveindicator Set the drive indicator LED
settime Sets unit time
ver
Version information
0+03:49:10.821 M0 GEM>
hid_set_ident
Sets or clears the locate indication on the enclosure Ops panel. The locate indication is used to aid in the
identification of the physical enclosure for maintenance.
Usage:
hid_set_ident <State>
Chapter 7. GEM CLI Commands 103
To Next Page
Loading...
