Table 23. Zoning Modes (continued)
Zoning
mode
Description D1212 D1224 D3284
5
Drives
partitioned
into 6 groups
with y-cable
N/A
Port A.0 -> Drives 0-
3
Port A.0 -> Drives 0, 1, 2, 14, 15, 28, 29, 42,
43, 44, 56, 57, 70, 71
Port A.1 -> Drives 4-
7
Port A.1 -> Drives 3, 4, 16, 17, 18, 30, 31,
45, 46, 58, 59, 60
Port B.0 -> Drives 8-
11
Port B.0 -> Drives 5, 6, 19, 20, 32, 33, 34,
47, 48, 61, 62, 74, 75, 76
Port B.1 -> Drives
12-15
Port B.1 -> Drives 7, 8, 9, 21, 22, 35, 36, 49,
50, 51, 63, 64, 77, 78
Port C.0 ->Drives 16-
19
Port C.0 ->Drives 10, 11, 23, 24, 25, 37, 38,
52, 53, 65, 66, 67, 79, 80
Port C.1 ->Drives 20-
23
Port C.1 ->Drives 12, 13, 26, 27, 39, 40, 41,
54, 55, 68, 69, 81, 82, 83
Note: A ‘.0’ or ‘.1’ In the port name indicates the use of a y-cable to split one x4 port into two x2 ports. .0 is the first
leg of the y-cable and .1 is the second leg of the cable.
Syntax :
set_zone_mode [mode]
mode A number between 0-254 detailing the drive partitioning scheme to be applied. Zone
mode 0 disables zoning permitting access to all drives from any host.
When run without arguments, this command returns the currently active zone mode.
Example:
0+07:15:06.839 M0 GEM> set_zone_mode
Current Zone Mode: 0
0+07:19:51.429 M0 GEM> set_zone_mode 1
0+07:19:51.429 M0 GEM> set_zone_mode
Current Zone Mode: 1
0+07:20:14.436 M0 GEM>
setcanisterindicator
Sets or clears the location indication for the ESM on which the command is executed.
Syntax:
setcanisterindicator <state>
state
1 – Enable ESM location indication
0 – Disable ESM location indication
Example:
0+03:03:11.579 M0 GEM> setcanisterindicator 1
0+03:05:17.297 M0 GEM> setcanisterindicator 0
0+07:29:06.202 M0 GEM>
setdriveindicator
Starts displaying a drive location indication on the specified drive bay. The drive location indication is used to
aid in locating a drive bay for servicing.
110
Lenovo Storage D1212/D1224/D3284Hardware Installation and Maintenance Guide
To Next Page
Loading...
