4. Move and place the strip between the chassis lid and the pop-up DDIC. Then, rotate the strip directly on
the top of the pop-up DDIC and fully open the top drawer at the same time.
Figure 67. Moving and placing the strip between the chassis lid and the pop-up DDIC
Figure 68. Rotating the strip
5. Remove the pop-up DDIC using the instructions in “Removing a DDIC ” on page 86.
6. Reinsert the DDIC into the drawer using the instructions in “Inserting a DDIC” on page 87.
Procedure B
Tools required:
• A flat head screwdriver (if needed)
Chapter 5. Troubleshooting and Problem Solving 69
To Next Page
Loading...
