Descriptions: When this option is enabled, a password prompt is displayed when the computer is turned
on or resumed from hibernation mode by an unattended event such as a Wake on LAN attempt. To
prevent unauthorized access, set the user authentication on the operating system.
• Password at Restart
Values: Disabled, Enabled
Descriptions: When this option is enabled, a password prompt is displayed when you restart the
computer. To prevent unauthorized access, set the user authentication on the operating system.
• Password at Boot Device List
Values: Disabled, Enabled
Descriptions: If you enable this option, the supervisor password is required when you try to enter the Boot
menu by repeatedly pressing F12. To use this function, a supervisor password must be set.
• Password Count Exceeded Error
Values: Disabled, Enabled
Descriptions: Enable this option to display the POST 0199 error message when you enter a wrong
supervisor password more than three times.
• Set Minimum Length
Values: Disabled, x characters (4 ≤ x ≤ 12)
Descriptions: Specify a minimum length for power-on passwords and hard disk passwords. If a supervisor
password is set, you cannot change the minimum length until you log in as a supervisor.
• Power-On Password
Values: Disabled, Enabled
Descriptions: Set a power-on password to protect the computer from unauthorized access. For more
information, see “Passwords introduction” on page 53.
• Hard Disk 1 Password
Values: Disabled, Enabled
Descriptions: Set a hard disk password to prevent unauthorized users from accessing data on the internal
storage drive. For more information, see “Passwords introduction” on page 53.
• Hard Disk 2 Password
Values: Disabled, Enabled
Descriptions: Set a hard disk password to prevent unauthorized users from accessing data on the internal
storage drive. For more information, see “Passwords introduction” on page 53.
Fingerprint
• Predesktop Authentication
Values: Disabled, Enabled
Descriptions: Enable or disable fingerprint authentication before the operating system is loaded.
• Reader Priority
Values: External ➙ Internal, Internal Only
Descriptions: If your computer has an internal fingerprint reader and an attached external fingerprint
reader, use this option to specify the fingerprint reader priority.
• Security Mode
Values: Normal, High
Chapter 6. Advanced configuration 71
To Next Page
Loading...
Need help?
General
Weight and Dimensions
