Notes: If you want to create a drive partition, select I will configure partitioning and click Done. In the
Manual Partitioning window, do one of the following to create a required drive partition:
• Manually create a root partition (/)
a. In the Manual Partitioning window, click + in the bottom left corner.
b. In the Add a New Mount Point window, select forward slash (/) from the Mount Point drop-down
list.
c. Type the amount of space (for example, 80 GB) in the Desired Capacity field.
d. Click Add mount point.
e. Change Device Type to Standard Partition.
• Manually create a boot partition (/boot/efi)
a. In the Manual Partitioning window, click + in the bottom left corner.
b. In the Add a New Mount Point window, select /boot/efi from the Mount Point drop-down list.
c. Type the amount of space (for example, 2 GB) in the Desired Capacity field.
d. Click Add mount point.
• Manually create a swap partition
a. In the Manual Partitioning window, click + in the bottom left corner.
b. In the Add a New Mount Point window, select swap from the Mount Point drop-down list.
c. Type the amount of space (for example, 2 GB) in the Desired Capacity field.
d. Click Add mount point.
Verify that the created drive partition is correct and click Done. In the Summary of Changes window,
click Accept Changes.
8. In the Installation Summary window, click Begin Installation to start installing the operating system.
9. During the installation, in the Configuration window, click Root Password to set the root password and
then click Done.
10. When the installation is completed, in the Configuration window, click Reboot.
11. In the Initial Setup window, click License Information.
12. Select I accept the license agreement and click Done.
13. In the Initial Setup window, click Finish Configuration.
14. In the Welcome window, select a required language (for example, English) and click Next.
15. In the Typing window, select a specific language type (for example, English US) and click Next.
16. In the Privacy window, set the location services as you are desired and click Next.
17. In the Time Zone window, set the time zone and click Next.
18. In the Online Accounts window, select your desired online account.
Note: Online Accounts is optional. Click Skip if you do not want to select an online account.
19. In the About You window, set the user name and click Next.
20. In the Password window, set the password and click Next.
Note: The password is optional. Click Next if you do not want to set a password.
21. In the Ready to Go window, click Start using Red Hat Enterprise Linux Server.
Note: By default, the local account is used to log in to the operating system for the first time. Log out
and use the root account to log in to the operating system again.
94
ThinkServer TD350 Operating System Installation Guide
To Next Page
Loading...
