15. If the Test Internet Connection window is displayed, you can choose to test the Internet connection or
skip the test. Then click Next.
16. In the Network Services Configuration window, click Next.
17. In the User Authentication Method window, select a user authentication method, for example, Local
(/etc/passwd). Then click Next.
18. In the New Local User window, configure the settings and then click Next.
19. In the Release Notes window, click Next.
20. In the Hardware Configuration window, click Next.
21. In the Installation Completed window, click Finish.
Note: If the YaST2 window is displayed, click Continue or Yes.
22. Follow the instructions on the screen to log in to the operating system.
Installing the SUSE Linux Enterprise Server 12 operating system
This topic provides instructions on installing the SUSE Linux Enterprise Server 12 operating system (x64).
Before you start the operating system installation, do the following to prepare the driver for RAID:
• Onboard RAID:
1. Download the driver for RAID from the Lenovo Web site. The most up-to-date device drivers for
various server models are always available on the Lenovo Web site at
http://www.lenovo.com/drivers.
Unzip the driver file if necessary. The extension of the driver file is .img usually, for example, /sles12/
DUDs/megasr-16.02.2014.1126-1-sles12-x86_64.img.
2. Run the following commands to copy the .img file structure and content to a USB storage device:
"mount -o loop *.image tmp_dir_1"
"mount /dev/usb_drive_partition tmp_dir_2"
"cp -a tmp_dir_1/* tmp_dir_2"
• Add-on RAID:
Download the driver for RAID from the Lenovo Web site, and copy the .iso file to a USB storage device.
Note: Insert the USB storage device into your server before you install the operating system.
To install the SUSE Linux Enterprise Server 12 operating system (x64), do the following:
1. Insert the operating system installation disc into the optical drive that you have set as the first startup
device. Then, start the server from the optical drive.
2. In the “SUSE Linux Enterprise Server Welcome” window, depending on the SATA configuration on your
serve, do one of the following:
• If your SATA configuration is set as onboard RAID, do the following:
a. Select Installation.
b. Press E to enter editing mode. Then modify the start parameter from linuxefi /boot/x86_64/
loader/linux to linuxefi /boot/x86_64/loader/linux brokenmosules=ahci.
c. Press F10 to load the operating system.
• If your SATA configuration is set as Add-on RAID, do the following:
a. Select Installation.
b. Press E to enter editing mode. Then input dud=1 and press F10.
c. After the driver is loaded, press Enter. If the “Please choose the Driver Update medium” window is
displayed, select Back.
70
ThinkServer TD350 Operating System Installation Guide
To Next Page
Loading...
