(1) Host interface card
(2) Thumbscrews
5.
Hand-tighten the HIC thumbscrews.
Do not use a screwdriver, or you might over-tighten the screws.
6.
Using a #1 Phillips screwdriver, attach the new HIC faceplate to the controller canister with the
four screws you removed previously.
6.3.7. Step 5: Reinstall controller canister
Reinstall the controller canister into the controller shelf after installing the new host interface card
(HIC).
Steps
1.
Reinstall the cover on the controller canister by sliding the cover from back to front until the
button clicks.
2.
Turn the controller canister over, so that the removable cover faces down.
3.
With the cam handle in the open position, slide the controller canister all the way into the
controller shelf.
110
To Next Page
Loading...
