(1) Host interface card (HIC)
(2) Thumbscrews
5.
Place the HIC on a static-free surface.
3.2.4. Step 3: Install new controller (duplex)
Install a new controller canister to replace the failed one. Perform this task only if your storage array
has two controllers (duplex configuration).
Step 3a: Install battery (duplex)
You must install the battery into the replacement controller canister. You can install the battery that
you removed from the original controller canister or install a new battery that you ordered.
Steps
1.
Turn the replacement controller canister over, so that the removable cover faces up.
2.
Press down on the cover button, and slide the cover off.
3.
Orient the controller canister so that the slot for the battery faces toward you.
4.
Insert the battery into the controller canister at a slight downward angle.
26
To Next Page
Loading...
