Possible hardware damage — The metal flange at the front of the battery
must be completely inserted into the slot on the controller canister (as shown
in the first figure). If the battery is not installed correctly (as shown in the
second figure), the metal flange might contact the controller board, causing
damage to the controller when you apply power.
◦ Correct — The battery’s metal flange is completely inserted in the slot on the controller:
◦ Incorrect — The battery’s metal flange is not inserted into the slot on the controller:
What’s next?
Go to Re-install DE2000H and DE4000H controller canister.
2.6. Re-install DE2000H and DE4000H canister
Reinstall the controller canister into the controller shelf after installing the new
battery.
Steps
1.
Reinstall the cover on the controller canister by sliding the cover from back to front until the
11
To Next Page
Loading...
