◦ Incorrect — The battery’s metal flange is not inserted into the slot on the controller:
Step 3b: Install host interface card (duplex)
If you removed a HIC from the original controller canister, you must install that HIC in the new
controller canister.
Steps
1.
Using a #1 Phillips screwdriver, remove the four screws that attach the blank faceplate to the
replacement controller canister, and remove the faceplate.
2.
Align the three thumbscrews on the HIC with the corresponding holes on the controller, and
align the connector on the bottom of the HIC with the HIC interface connector on the controller
card.
Be careful not to scratch or bump the components on the bottom of the HIC or on the top of
the controller card.
3.
Carefully lower the HIC into place, and seat the HIC connector by pressing gently on the HIC.
28
To Next Page
Loading...
