(1) Internal Cache Active LED
(2) Battery
4.
Using a #1 Phillips screwdriver, remove the four screws that attach the blank faceplate to the
controller canister, and remove the faceplate.
5.
Align the three thumbscrews on the HIC with the corresponding holes on the controller, and
align the connector on the bottom of the HIC with the HIC interface connector on the controller
card.
Be careful not to scratch or bump the components on the bottom of the HIC or on the top of
the controller card.
6.
Carefully lower the HIC into place, and seat the HIC connector by pressing gently on the HIC.
Possible equipment damage — Be very careful not to pinch the gold ribbon
connector for the controller LEDs between the HIC and the thumbscrews.
119
To Next Page
Loading...
