8.
Place the drive on an antistatic, cushioned surface away from magnetic fields.
9.
Wait 30 seconds for the software to recognize that the drive has been removed.
If you accidentally remove an active drive, wait at least 30 seconds, and then
reinstall it. For the recovery procedure, refer to the storage management
software.
5.3.5. Step 3: Install new drive
Install a new drive to replace the failed one.
Install the replacement drive as soon as possible after removing the failed drive.
Otherwise, there is a risk that the equipment might overheat.
Possible loss of data access — When pushing the drive drawer back into the
enclosure, never slam the drawer shut. Push the drawer in slowly to avoid jarring
the drawer and causing damage to the storage array.
Steps
1.
Raise the cam handle on the new drive to vertical.
2.
Align the two raised buttons on each side of the drive carrier with the matching gap in the drive
channel on the drive drawer.
65
To Next Page
Loading...
