of the drive shelf.
If you are performing this procedure with the power on, all LEDs turn off when you disconnect
the last cable chain connector, including the amber Attention LED.
12.
Replace the left fan canister. If the drive shelf is receiving power, confirm that the amber LED on
the back of the fan is not illuminated and that air is coming out the back of the fan.
The LED could remain on for as long as a minute after you reinstall the fan while both fans settle
into the correct speed.
5.4.5. Step 3: Remove failed drive drawer
Remove a failed drive drawer to replace it with a new one.
Possible loss of data access — Magnetic fields can destroy all data on the drive
and cause irreparable damage to the drive circuitry. To avoid loss of data access
and damage to the drives, always keep drives away from magnetic devices.
Steps
1.
Make sure that:
◦ The right and left cable chains are disconnected.
◦ The right and left fan canisters are replaced.
2.
Remove the bezel from the front of the drive shelf.
3.
Unlatch the drive drawer by pulling out on both levers.
4.
Using the extended levers, carefully pull the drive drawer out until it stops. Do not completely
remove the drive drawer from the drive shelf.
5.
If volumes have already been created and assigned, use a permanent marker to note the exact
location of each drive. For example, using the following drawing as a reference, write the
appropriate slot number on the top of each drive.
77
To Next Page
Loading...
