Risk of equipment malfunction — If the connectors are not latched, the
cable chain might come loose during drawer operation.
5.
Reinstall the right fan canister. If the drive shelf is receiving power, confirm that the amber LED
on the back of the fan is now off and that air is now coming out of the back.
The LED could remain on for as long as a minute after you reinstall the fan while the fan settles
into the correct speed.
6.
From the back of the drive shelf, remove the fan canister on the left side of the shelf.
7.
If the shelf is powered on, ensure that the right fan goes to its maximum speed.
Possible equipment damage due to overheating — If the shelf is powered
on, do not remove both fans at the same time. Otherwise, the equipment
might overheat.
8.
Reattach the left cable chain:
a.
Locate the horizontal and vertical connectors on the cable chain and their corresponding
horizontal and vertical guide rails inside the enclosure.
b.
Align both cable chain connectors with their corresponding guide rails.
c.
Slide the cable chain’s horizontal connector into the horizontal guide rail and push it in as
far as it will go.
Risk of equipment malfunction — Make sure to slide the connector
within the guide rail. If the connector rests on the top of the guide rail,
problems might occur when the system runs.
d.
Slide the vertical connector on the left cable chain into the vertical guide rail.
e.
After you reconnect both ends of the cable chain, carefully pull on the cable chain to verify
that both connectors are latched.
Risk of equipment malfunction — If the connectors are not latched, the
cable chain might come loose during drawer operation.
9.
Reinstall the left fan canister. If the drive shelf is receiving power, confirm that the amber LED
on the back of the fan is now off and that air is now coming out of the back.
The LED could remain on for as long as a minute after you reinstall the fan while both fans settle
into the correct speed.
5.4.8. Step 6: Complete drive drawer replacement
Reinsert the drives and replace the front bezel in the correct order.
83
To Next Page
Loading...
