and that the amber LED on the back of the fans is off.
5.4.9. What’s next
Your drive drawer replacement is complete. You can resume normal operations.
5.5. Hot add a drive to a system
You hot-add a drive that contained previous configuration information to a
system.
NOTE:
•
Make sure the inserted drive is usable.
•
Do not power down the system when hot adding drive to an existing system.
•
Add drives to system one drive at a time. Give enough time for drive to be recognized by the
system.
5.5.1. Steps
1.
Do one of the followings according to your system:
◦ Hot-add drive to a 60-drive system. Refer to
Replace drive (60-drive)
◦ Hot-add drive to a 12-drive or 24-drive sytem. Refer to Replace drive (12-drive or 24-drive)
After each drive insertion, check the MEL to insure that the drive has been added. If there are any
errors while adding drives, check the Recovery Guru and follow Recovery Guru procedures to fix
any problems prior to adding additional drives
87
To Next Page
Loading...
