If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the air baffle
Use this information to install the air baffle.
Before you install the air baffle, complete the following steps:
1. Read “Safety” on page iii and “Installation Guidelines” on page 21 to ensure that you work safely.
To install the air baffle, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
• Youku: http://list.youku.com/albumlist/show/id_50481482
Figure 15. Air baffle installation
Step 1. Align the air baffle pins with the pin holes on both sides of the chassis; then, lower the air baffle into
the compute node. Press the air baffle down until it is securely seated.
Note: Close the retaining clip on each end of the DIMM connector before installing the air baffle.
After you install the air baffle, complete the following steps:
1. Install the compute node cover (see “Install the compute node cover” on page 43 ).
2. Install the compute node into the chassis (see “Install the compute node in the chassis” on page 25 ).
3. Power on the compute node.
Adapter-retention assembly replacement
Use the following information to remove and install the adapter-retention assembly.
Remove the adapter-retention assembly
Use this information to remove the adapter-retention assembly.
32
ThinkSystem SN550 Compute Node Maintenance Manual
To Next Page
Loading...
