When you remove the fabric connector, the UEFI firmware holds the Ethernet controller in reset and displays
a warning message, if an I/O expansion adapter is not installed in the I/O expansion connector 1 to provide
connectivity to the chassis.
To remove a fabric connector, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
• Youku: http://list.youku.com/albumlist/show/id_50481482
Figure 31. Fabric connector removal
Step 1. Locate the fabric connector on the system board (see “System-board connectors” on page 13).
Step 2. Using a long shank #1 Phillips screwdriver, loosen the four captive screws that secure the fabric
connector.
Step 3. Lift the fabric connector from the system board and store it in a safe place.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
If you have removed the fabric connector to install an I/O expansion adapter in I/O expansion connector 1,
keep the fabric connector in a safe place for future use.
Install a fabric connector
Use this information to install a fabric connector.
Before you install a fabric connector, complete the following steps:
1. Read “Safety” on page iii and “Installation Guidelines” on page 21 to ensure that you work safely.
2. Obtain a long shank #1 Phillips screwdriver.
To install a fabric connector, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
50
ThinkSystem SN550 Compute Node Maintenance Manual
To Next Page
Loading...
