CAUTION:
Hot surface nearby.
Remove the air baffle
Use this information to remove the air baffle.
Before removing the air baffle:
1. Read “Safety” on page iii and “Installation Guidelines” on page 21 to ensure that you work safely.
2. Power off the corresponding compute node that you are going to perform the task on.
3. Remove the compute node from the chassis (see “Remove the compute node from the chassis” on page
24).
4. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the
bezel pointing toward you.
5. Remove the compute node cover (see “Remove the compute node cover” on page 42).
To remove the air baffle, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
• Youku: http://list.youku.com/albumlist/show/id_50481482
Figure 14. Air baffle removal
Step 1. Lift the air baffle up and set it aside.
Attention: For proper cooling and airflow, reinstall the air baffle before you turn on the compute
node. Operating the compute node with the air baffle removed might damage compute node
components.
Chapter 3. Hardware replacement procedures 31
To Next Page
Loading...
