5. Remove the compute node cover (see “Remove the compute node cover” on page 42).
Note: This section only applies to RAID adapters that come with a flash power module.
To remove the flash power module, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
• Youku: http://list.youku.com/albumlist/show/id_50481482
Figure 33. Flash power module removal
Step 1. Remove the RAID adapter (see “Remove a RAID adapter” on page 78 ).
Step 2. Carefully turn the RAID adapter over in your hand to access the underside. Press down on the rear
of the flash power module; then, slide the flash power module out of its holder on the RAID adapter.
Step 3. Disconnect the flash power module cable from the RAID adapter.
Attention: To prevent any damage to the flash power module cable or connector, it is important to
first slide out the flash power module. This provides more space for your fingers to better grip the
flash power module cable and remove it from the connector.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the flash power module
Use this information to install the flash power module.
Before you install the flash power module, complete the following steps:
1. Read “Safety” on page iii and “Installation Guidelines” on page 21 to ensure that you work safely.
Note: This section only applies to RAID adapters that come with a flash power module.
To install the flash power module, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
• Youku: http://list.youku.com/albumlist/show/id_50481482
52
ThinkSystem SN550 Compute Node Maintenance Manual
To Next Page
Loading...
