Before you install the RFID tag, read
1. Read “Safety” on page iii and “Installation Guidelines” on page 21 to ensure that you work safely.
To install the RFID tag, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-B4_LYuT9X1MRWBU6UzX9gO
• Youku: http://list.youku.com/albumlist/show/id_50481482
Figure 60. RFID tag installation
Step 1. Make sure that the surface you are installing the tag on is thoroughly clean and dry.
Step 2. Open the RFID tag; then, remove the backing from the base of the RFID tag to expose the
adhesive.
Step 3. Position the RFID tag over the ID label on the front panel of the compute node.
Step 4. Press the RFID tag securely against the bezel and hold firmly in place for 30 seconds.
Notes:
• Allow 30 minutes before closing or opening the RFID tag.
• Allow 24 hours to achieve near maximum adhesion.
Chapter 3. Hardware replacement procedures 77
To Next Page
Loading...
