Lenovo ThinkSystem SN550 - Chapter 4. Problem Determination

Step 2. After you have OneCLI in place, use the following command syntax to set the UUID:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value> [access_method]
Where:
<uuid_value>
Up to 16-byte hexadecimal value assigned by you.
[access_method]
The access method that you selected to use from the following methods:
• Online authenticated LAN access, type the command:
Example that does not use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SYsInfoUUID <uuid_value> --user <user_id>
--password <password>
Example that uses the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
• Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this access method.
Example:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
Note: The KCS access method uses the IPMI/KCS interface, which requires that the IPMI
driver be installed.
• Remote LAN access, type the command:
Note: When using the remote LAN access method to access Lenovo XClarity Controller
using the LAN from a client, the host and the bmc_external_ip address are required
parameters.
[−−bmc bmc_user_id:bmc_password@bmc_externaln _ip]
Where:
bmc_external_ip
The external BMC (Lenovo XClarity Controller) LAN IP address. There is no default
value. This parameter is required.
bmc_user_id
The BMC (Lenovo XClarity Controller) account (1 of 12 accounts). The default value is
USERID.
bmc_password
The BMC (Lenovo XClarity Controller) account password (1 of 12 accounts). The default
value is PASSW0RD (with a zero 0 not an O).
Example that does not use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SYsInfoUUID <uuid_value>
[−−bmc bmc_user_id:bmc_password@bmc_internal_ip]
Example that does use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
Step 3. Restart the Lenovo XClarity Controller.
Step 4. Restart the server.
Chapter 3. Hardware replacement procedures 87