• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Install the drive backplane.
Figure 29. Installing the drive backplane
Align the tabs on the bottom of the drive backplane with the slots on the system board, and
insert them into the slots.
Push the top of the drive backplane forward until it clicks in place.
After this task is completed
Proceed to complete the parts replacement (see “Complete the parts replacement” on page 218).
Install a 2.5-inch hot-swap drive
Follow instructions in this section to install a 2.5-inch hot-swap drive.
About this task
Attention:
• Go over “Installation Guidelines” on page 107 to ensure that you work safely.
Notes: The server supports up to three drive backplanes with the following corresponding drive bay
numbers.
Figure 30. Drive backplane numbering
Chapter 4. Hardware replacement procedures 113
To Next Page
Loading...
