“ ” on page 56 “ ” on page 254 “
” on page 57
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you install an M.2 drive, if the M.2 backplane is installed in the server, remove it. See “Remove the
M.2 backplane” on page 342.
Complete the following steps to install an M.2 drive in the M.2 backplane.
Watch the procedure. A video of the installation process is available:
•
YouTube
• Youku
“ ” on page 57
Step 1. Locate the connector on each side of the M.2 backplane.
Step 2. Insert the M.2 drive.
Figure 43. Inserting the M.2 drives
Insert the M.2 drive at an angle (approximately 30 degrees) into the connector and rotate it until the
notch catches on the lip of the retainer
Notes:
• When installing two drives, align and support both drives before sliding the retainer forward to
secure the drives.
• When only one drive is installed, it must be in slot 0.
236
ThinkSystem SR950 Setup Guide
To Next Page
Loading...
