Table 34. Adapter LEDs (continued)
Callout Callout
11 Adapter 11 fault LED 25 ML2 x16 network adapter fault LED
12 Adapter 12 fault LED 26 Adapter 7 fault LED
13 Adapter 13 fault LED 27 Adapter 6 fault LED
14 Adapter 14 fault LED 28 Adapter 5 fault LED
Internal cable routing
Some of the components in the server have internal cables and cable connectors.
Note: Disengage all latches, release tabs, or locks on cable connectors when you disconnect cables. Failing
to release them before removing the cables will damage the cable connectors or the cable sockets on circuit
boards, which are fragile. Any damage to the cable connectors or cable sockets might require replacing the
cables or circuit boards.
Some options, such as RAID controllers, might require additional internal cabling. See the documentation
that is provided for the option to determine any additional cabling requirements and instructions.
Cable guides
Make sure that all the cables go through the cable guides, as shown in each cabling section.
Chapter 2. Server components 35
To Next Page
Loading...
