Cable routing for common components
Use this section to understand how to route cables for common server components.
Cable routing for common components is different for the lower and upper trays:
• “Common cable routing (lower tray)” on page 37
• “Common cable routing (upper tray)” on page 39
Notes:
• Make sure that all the cables go through the cable guides, as shown in the illustrations. See “Cable
guides” on page 35 for cable guide locations and descriptions.
• Some cable connectors have locks or latches that must be disengaged to disconnect the cable.
Common cable routing (lower tray)
The following illustration shows cable routing for common components in the lower tray.
Chapter 2. Server components 37
To Next Page
Loading...
