Memory air baffle replacement
Use the following procedures to replace a memory air baffle.
Remove a memory baffle
Memory air baffles are in the system boards that are accessed from the front of the server.
“
” on page 56 “ ” on page 254 “
” on page 57
Before you remove a memory air baffle:
1. Remove the front cover. See “Remove the front cover” on page 322.
2. Remove the compute tray where the system board and memory air baffles are installed. See “Remove a
compute tray” on page 305.
3. If you are removing a memory air baffle from the lower compute system board, remove the upper system
board or system board filler. See “Remove a system board” on page 309.
Complete the following steps to remove a memory air baffle.
Watch the procedure. A video of the replacement process is available:
•
YouTube
• Youku
Note: Each memory air baffle spans six memory modules.
Step 1. Open the six pairs of memory module connector retaining clips that span the memory air baffle.
Step 2. Slide the memory air baffle up and off of the memory module connector retaining clips; then,
remove the air baffle from the compute system board.
350
ThinkSystem SR950 Setup Guide
To Next Page
Loading...
