CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
“
” on page 56 “ ” on page 254
Before you remove an adapter from slot 16 to 17:
1. Disconnect and label all cables connected to adapters in the I/O tray; then, remove the I/O tray. See
“Remove the I/O tray” on page 334.
2. Remove the riser for slot 16 to 17. See “Remove the riser for slot 16 to 17 (riser 3)” on page 362.
Complete the following steps to remove an adapter from slot 16 to 17.
Watch the procedure. A video of the installation process is available:
•
YouTube
• Youku
Figure 70. Adapter removal (slot 16 to 17)
Step 1. Open the retention latch.
298
ThinkSystem SR950 Setup Guide
To Next Page
Loading...
