Troubleshooting and fault elimination
8-6
48XX/49XXSHB0399
8.4 Reset of fault indications
TRIP
After eliminating the fault, pulse inhibit will only be reset after the acknowledgement
of TRIP.
TRIP acknowledgement:
( Change to the parameter level of C067 and acknowledge with SH+PRG
( LECOM: C043 = 0
( Terminal X2/E2 (reset trip)
( Control word AIF
( Mains switching
Note!
If a TRIP source is still active, TRIP cannot be reset.
Message
After eliminating the fault, the pulse inhibit will be reset automatically.
To Next Page
Loading...
