Lenze 4800 - Page 335

Index
18-5
48XX/49XXSHB0399
FAI, 7-29
Fault
Cause, 8- 4
History buffer, 8-3
Remedy, 8- 4
Reset, 12- 1
Fault indication
Display priority, 7-98
Reset, 8-6
Fault message, 8-4
FDI, 7-22
FDO, 7-24
Features, Controller, 3-1
Field controller
Field current monitoring, 7-28
Mains chokes, 13-8
Separate supply, 4-9
Field current reduction, 7-61
Field heating, 7-61
Field weakening operation, 7-15
Fieldbus connection
InterBus, 4- 27
Interface enable, 12-3
PROFIBUS, 4-28
Fixed set-value, 7-77
Following error, 7-54
Fuse, 13-2
Holder, 13-5
Internal, 13-5
Fuse holder, Dimensions, 13-5
G
Gain
Adaption, 7-140
Analog inputs, 7-20, 7-122
Angle controller, 7-137
Armature circuit, 7-14
Field controller, 7-127
Field current controller, 7-16
Monitor outputs, 7-19
Process controller, 7-136
Speed controller, 7-18
Gases, 3-3
Gearbox, Limitation of rate of rise, 7-139
Gearbox factor, 7-39
Digital frequency cascade, 7- 48
Fixed set-values, 7-77
Speed-synchronous running, 7-51
Ground, Earth loops, 8-4
Grounding, 4-32
RFI filter, 4- 29
H
History buffer, 8-3
Hoist, 4-20
Hoists, Overspeeds, 2-3
Holding brake, 7-62
I
I component
Process controller, 7-67, 7-69
Quick stop, 7- 63
Speed controller, 7-18
Identification, 7-118
IMP, 7-109, 8-2
Incremental encoder
Connection, 4-22
Monitoring, 4-23
Parameter setting, 7-13
Supply, 4-23
Input of the direction of rotation, 7-37,
7-45, 7-48
Inputs
Analog, 4-15
Digital, 4-19
FAI, 7- 29
FDI, 7- 22
Free assignable analog, 7-29
Freely assignable digital, 7-22
Freely assignable, analog, 5-9
Freely assignable, digital, 5-8
Instability
Armature circuit, 7-14
Show/Hide Bookmarks