Lenze 8203 - User Manual

Questions and Answers

C
chenryAug 30, 2025
Why Lenze Inverter motor does not rotate smoothly?
- H
  helen96Aug 30, 2025
  If the Lenze Inverter motor isn't rotating smoothly: * The motor cable might be defective, so replace it. * The maximum current settings (C022 and C023) might be too low, so adjust them. * The motor might be underexcited or overexcited, so check the parameter setting.
V
valeriematthewsAug 29, 2025
How to reduce high current consumption of motor with Lenze Inverter?
- R
  Russell KnightAug 29, 2025
  If the motor's current consumption is too high when using a Lenze Inverter: * Reduce the setting of C016. * Increase the setting of C015. * Adapt C088 and C091 to the motor data.
L
Lisa GarciaAug 28, 2025
What causes OC1 short circuit in Lenze Inverter?
- A
  Aaron OconnellAug 28, 2025
  If your Lenze Inverter displays an OC1 (Short circuit) error, it could be due to: * A short circuit. Find out the cause of the short circuit and check the cable. * Excessive capacitive charging current of the motor cable. Use a motor cable that is shorter or of lower capacitance.
H
Heather HernandezAug 27, 2025
How to fix Lenze Inverter heat sink temperature too high?
- M
  Michael DonaldsonAug 27, 2025
  If the heat sink temperature of your Lenze Inverter is too high, consider the following: * The ambient temperature might be too high (Tamb > +40 C or +50 C). Allow the controller to cool and ensure proper ventilation. Also, check the ambient temperature in the control cabinet. * The heat sink might be dirty, so clean it. * The mounting position might be incorrect, so change it.
A
Angie BradfordAug 27, 2025
What to do if Lenze Inverter shows OOV overvoltage error?
- L
  Lori JonesAug 27, 2025
  If your Lenze Inverter displays an OOV (Overvoltage) error, it could be due to: * Mains voltage being too high, check the voltage supply. * Feedback or braking operation issues. Try increasing deceleration times. If using brake choppers, check the selection and connection of the brake resistor and increase the deceleration times. * Earth leakage on the motor side. Inspect the motor cable and motor for earth faults, disconnecting the motor from the inverter to do so.
W
wongsherryAug 25, 2025
Why Lenze Inverter motor does not rotate?
- C
  Carlos RichardsAug 26, 2025
  If the Lenze Inverter motor isn't rotating, it could be due to several reasons: * The DC-bus voltage might be too low, in this case check the mains voltage. * The controller might be inhibited, so check the operating module. * The setpoint might be zero, so set a proper setpoint. * DC braking or the quick-stop function could be active, so disable them. * If a JOG setpoint is activated but the JOG frequency is zero, set the JOG frequency. * A fault might be indicated (refer to chapter 8.3 for fault details). * The mechanical motor brake might not be released, so release it.
C
Crystal RobertsAug 25, 2025
What causes faulty auto-TRIP reset in Lenze DC Drives?
- S
  Stephanie FitzgeraldAug 25, 2025
  If you have a faulty auto-TRIP reset on your Lenze DC Drives, it could be due to more than 8 fault messages in 10 minutes. The solution depends on the specific fault message.