Lenze 9300 - Page 363

Configuration
7-246

SHB9300CRV EN 2.0
Fault message Possible reactions
Display CodeoffQWMTMeaning
OH Heatsink temperature 1 (max. permissible, fixed) - - - - - -
OH3 Motor temperature 1 (max. permissible, fixed) - - - - T C0583
OH4 Heatsink temperature 2 (adjustable; C0122) - - - - T C0582
OH7 Motor temperature 2 (can be set; code: C0121) - - - - T C0584
OH8 Motor temperature (fixed) via inputs T1/T2 T - T
*
- - C0585
OU Overvoltage on the DC bus - - - - - -
P01 Limit switch negative = LOW T - - - - C1285/1
P02 Limit switch positive = LOW T - - - - C1285/2
P03 Contouring error - digital frequency > C0255 T - - - T C0589
P04 Position limit negative exceeded T - - - - C1285/3
P05 Position limit positive exceeded T - - - - C1285/4
P06 No reference T - - - - C1287/1
P07 Parameter set mode absolute T - - - - C1291/1
P08 Actaul offset out of range T - - - - C1291/2
P09 Impermissible programming T - - - - C1291/3
P12 Encoder range exceeded T - - - - C1288/1
P13 Phase overflow - - T - T C0590
P14 1. contouring error POS > C1218/1 T - T - T C1286/1
P15 2. contouring error POS > C1218/2 T - T T - C1286/2
P16 Sync error T - T - T C1290/1
P17 TP control error T - T - T C1289/1
P18 Internal limitation T - - T T C1289/2
PEr Program error - - - - - -
PI Fault during initialization - - - - - -
PR0 General fault in parameter sets - - - - - -
PR1 Fault in parameter set 1 - - - - - -
Sd2 Resolver fault - - T
*
- T C0586
Sd3 Encoder fault at X9 PIN 8 T - T
*
- - C0587
Sd5 Encoder fault at X6/1 X6/2 (C0034 = 1) T - T - - C0598
Sd6 Sensor fault: motor temperature (X7 or X8) - - T - T C0594
Sd7 Fault in the absolute value encoder at X8 T - - - - C0025
TTRIP
-
Lenze
M Message
T
possible
W Warning - not possible
QFault/QSP
T
* possible, the drive may be destroyed if the fault is not eliminated in time
Show/Hide Bookmarks