T
Commissioning
Selection of the correct operating mode
EDK82MV222 DE/EN/FR 9.0
L
NNM
léÉê~íáåÖ ãçÇÉë êÉÅçããÉåÇÉÇ Ñçê ëí~åÇ~êÇ ~ééäáÅ~íáçåë
qÜÉ ÑçääçïáåÖ í~ÄäÉ ÜÉäéë óçì íç ÑáåÇ íÜÉ ÅçêêÉÅí çéÉê~íáåÖ ãçÇÉ Ñçê ëí~åÇ~êÇ
~ééäáÅ~íáçåëW
Application Operating mode
Single drives
Setting in C0014
recommended alternatively
With extremely alternating loads 4 2
With high starting duty 4 2
With speed control (speed feedback) 2 4
With high dynamic response (e. g. positioning and infeed drives) 2 -
With torque setpoint 5 -
With torque limitation (power control) 2 4
Three-phase AC reluctance motors 2 -
Three-phase sliding rotor motors 2 -
Three phase motors with assigned frequency-voltage characteristic 2 -
Pump and fan drives with square-law load characteristic 3 2or4
Group drives
(several motors connected to one controller)
Identical motors and identical loads 2 -
Different motors and/or changing loads 2 -
`MMNQ Z OW äáåÉ~ê sLÑ ÅÜ~ê~ÅíÉêáëíáÅ Åçåíêçä
`MMNQ Z PW ëèì~êÉJä~ï sLc ÅÜ~ê~ÅíÉêáëíáÅ Å çåíêçä
`MMNQ Z QW îÉÅíçê Åçåíêçä
`MMNQ Z RW ëÉåëçêäÉëë íçêèìÉ Åçåíêçä
efesotomasyon.com - Lenze
To Next Page
Loading...
